-
-
Notifications
You must be signed in to change notification settings - Fork 9
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Dedicated article for UNO R4 WiFi's with missing USB bridge firmware [HC-1549] #436
base: main
Are you sure you want to change the base?
Conversation
… firmware on UNO R4 WiFi with espflash"
There was a problem hiding this comment.
Choose a reason for hiding this comment
The reason will be displayed to describe this comment to others. Learn more.
Left some suggestions regarding my experience following the instructions on macOS.
Follow these steps: | ||
|
||
1. Unplug any non-essential USB devices from your computer. | ||
1. Short the pins highlighted in the image using a jumper wire: |
There was a problem hiding this comment.
Choose a reason for hiding this comment
The reason will be displayed to describe this comment to others. Learn more.
1. Short the pins highlighted in the image using a jumper wire: | |
1. Short the pins highlighted in the image using a jumper wire (shorting the pins is only necessary during steps 2 and 3): |
This suggestion can also be written in a [!TIP] box.
content/Hardware Support/UNO/Restore-the-connectivity-firmware-on-UNO-R4-WiFi-with-espflash.md
Outdated
Show resolved
Hide resolved
content/Hardware Support/UNO/Restore-the-connectivity-firmware-on-UNO-R4-WiFi-with-espflash.md
Show resolved
Hide resolved
content/Hardware Support/UNO/Restore-the-connectivity-firmware-on-UNO-R4-WiFi-with-espflash.md
Outdated
Show resolved
Hide resolved
content/Hardware Support/UNO/Restore-the-connectivity-firmware-on-UNO-R4-WiFi-with-espflash.md
Outdated
Show resolved
Hide resolved
There was a problem hiding this comment.
Choose a reason for hiding this comment
The reason will be displayed to describe this comment to others. Learn more.
Correct instructions for Windows 🌞
``` | ||
|
||
1. Close the terminal window. | ||
1. Disconnect the USB cable of the **UNO R4 WiFi** board from your computer. |
There was a problem hiding this comment.
Choose a reason for hiding this comment
The reason will be displayed to describe this comment to others. Learn more.
1. Disconnect the USB cable of the **UNO R4 WiFi** board from your computer. | |
1. Disconnect the USB cable and the jumper wire from the **UNO R4 WiFi** board. |
There was a problem hiding this comment.
Choose a reason for hiding this comment
The reason will be displayed to describe this comment to others. Learn more.
We will recommend removing the connection between the ESP32 pins earlier in the procedure, as discussed here. So there should be no jumper wire to remove at this step. Perhaps a reminder could still be warrented, I will heck back on this after we've resolved the other conversation.
Co-authored-by: Renat0Ribeir0 <[email protected]>
Split the espflash instructions from Update the connectivity module firmware on UNO R4 WiFi into a dedicated article.