-
|
I'm trying to print a piece with a perfect finish using my custom idex machine. In order to do that, i have one material in T0 and other one in T1. Also, i'm using purge tower. I have noticed that when i enable the purge tower, when a toolchange is commanded, right after that, a movement to almost origin is commanded, and i don't know how to avoid this. I haven't got this movement configured in any of my scripts, so i understand this is controlled by the purge tower settings, but i can't find it. Any ideas? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
I have found that this happens when I set a offset between my extruders! If i set to 0 the offset in extruder 2 (T1), this problem dissapears. |
Beta Was this translation helpful? Give feedback.
I have found that this happens when I set a offset between my extruders! If i set to 0 the offset in extruder 2 (T1), this problem dissapears.
I dunno if this is done on purpose, but i think it shouldn't do this travel anyways. (I prefer to set the offsets in orcaslicer instead of the firmware (in my case klipper)